different AT91C_LENGTH_FRAME values
Correct me if i’m wrong, but shouldn’t AT91C_LENGTH_FRAME for TxDescriptor be different than AT91C_LENGTH_FRAME_RX for RxDescriptor in SAM7_EMAC.c ?
reading the AT91SAM7X specs, Table 38-1 mentions RxDescriptor "Length of frame" field to be 11:0 thats 0x0fff and not 0x07ff
while Table 38-2 mentions RxDescriptor "Length of frame" field to be 10:0 that’s what should be 0x07ff
we would define
AT91C_LENGTH_FRAME_TX 0x07ff
AT91C_LENGTH_FRAME_RX 0x0fff
there are only a couple of lines to be changed there after in SAM7_EMAC.c
am i correct?
different AT91C_LENGTH_FRAME values
This has come up before. I cannot remember what the conclusion was. I also cannot search the forum to find the thread, I just get permission denied message.
Are you able to search the forum? If so can you post a link to what you find.
different AT91C_LENGTH_FRAME values
The SourceForge status page is showing a problem with search.
https://sourceforge.net/docs/A04
different AT91C_LENGTH_FRAME values
well as of version 4.0.4, its still the same value that is programmed.
different AT91C_LENGTH_FRAME values
Sorry to miss this guys. I have corrected it within Subversion and added it to the known issues list.
Regards.